Insufficient pressure of glassware cleaning machine? What may be the reason for the poor cleaning effect

The glassware cleaning machine is a digestion tank, volumetric flask, centrifuge tube, beaker, and other inorganic element residues used in trace analysis of inorganic elements, such as glass quartz, PDF, PTFE, TFM, etc. It has functions such as acid gas cleaning, ultra pure water washing, and drying.
Next, let's analyze the four common causes and solutions of usage failures in glassware cleaning machines!
1. Insufficient spray pressure
Insufficient spray pressure during the operation of the glassware cleaning machine can affect the cleaning effect, which may be caused by the following three reasons:
(1) Insufficient cleaning solution, low liquid level, should increase cleaning solution and raise the liquid level.
(2) The water pump is not running properly, and the technical engineer should check and handle the corresponding fault as soon as possible.
(3) The accumulation of debris in the filter is not timely cleaned, resulting in high resistance. It is recommended to clean the filter as soon as possible to remove all debris.
2. Slow heating up
The instrument is operating normally, but the temperature of the cleaning solution rises slowly, which may be caused by the following two reasons:
(1) If the condensate from the heater is not discharged smoothly, you can open the bypass valve of the steam trap to drain it completely;
(2) There is a significant accumulation of scale in the heater, which affects its thermal conductivity. Regular descaling is necessary.
3. Poor cleaning effect
After cleaning, it was found that some bottles did not clean well and did not meet the experimental requirements. This may be due to the following three reasons:
(1) The low temperature of the cleaning solution affects the cleaning effect, and the temperature of the cleaning solution should be adjusted in a timely manner;
(2) The nozzle is blocked, which affects cleaning. The nozzle should be unblocked in a timely manner.
(3) The detergent produces too much foam. It is recommended to improve the detergent formula.
4. The utensils are severely damaged
After cleaning, it was found that there were many damaged bottles, which may be caused by the following three reasons:
(1) If there is a quality issue with the glassware itself, it is necessary to replace it with a qualified one in a timely manner;
(2) When certain malfunctions occur in the glassware cleaning machine, technical engineers should conduct a comprehensive inspection of the instrument, identify the cause, and promptly resolve it;
(3) When entering the bottle, the temperature is too low, causing a sudden change in temperature, which can increase the temperature of the bottle.